The LED's shown on an operating system are summarized below.

Control Unit LEDs

LED

Description

Optional SD

•Off = Card shutdown.

•Green on = Card present.

•Green flashing = Card in use.

•Orange steady = Reset imminent.

•Red flashing = Card initializing or shutting down.

•Red fast flashing = card full

•Red steady = Card failure/wrong type.

System SD

CPU

•Alternate red/green = Starting up.

•Green on = Okay.

•Red on = No software.

•Flashing Red = Error/Shutdown.

Base Card LEDs

Note: Cards not supported by the system's particular mode, locale or level of software will display a solid red LED.

Base Card

LEDs 1 to 8 Usage

All Cards

•LED1 is also used for base card status:

•Red On = Error/Not supported.

•Red Slow Flash = Initializing.

•Red Flash every 5 seconds = Card okay.

•Red Fast Flash = System shutdown.

IP500 Analog Phone

•No status LEDs are used for analog phone extensions.

IP500 Digital Station

•Green Flashing = Phone detected.

•Green On = Phone active.

IP500 Combination

LEDs 1 to 6

•Green Flashing = Phone detected.

•Green On = Phone active.

 

 

Trunk Daughter Card LEDs

Trunk Daughter Card

LEDs 9 to 12 Usage

All cards

•LED 9 is also used for daughter card status.

•Red On = Error

•Red Slow Flash = Initializing.

•Red Flash every 5 seconds = Card okay.

•Red Fast Flash = System shutdown.

Analog Trunk

•Green on = Line connected to the port but idle.

•Green flashing = Line in use.

PRI Trunk

•Off = No trunk present.

•Green on = Trunk present.

•Green flashing = Trunk in use.

•Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication signal (AIS) from the trunk remote end.

•Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode (set through IP Office System Monitor).

BRI Trunk

•Off = No trunk present.

•Green on = Trunk present.

•Green flashing = Trunk in use.

 

External Expansion Module LEDs

Module

LEDs

All

The center LED on all external expansion modules is used to indicate the overall state of the module as follows:

•Red flashing = Module starting up/Loading firmware.

•Red on = Error.

•Green on = Module okay.

•Green flashing = Module starting up/Loading firmware (IP500 DS16A/30A module only).

Analog Trunk 16

•None.

BRI So8

•Green On = Connected.

•Green Flashing = Activity.

Digital Station 16/30

•Green Flashing = Phone detected.

•Green On = Phone active.

Digital Station 16A/30A

•Green On = Phone detected.

Phone

•None.