Enabling IP Office Web Manager

Access to IP Office Web Manager is via the system's IP address and then selecting the IP Office Web Management link. In order to use IP Office Web Manager, a number of criteria as listed below must be met. Most of these are applied automatic to a new system installed with IP Office Release 8.0 or higher. However, for systems being upgraded to IP Office Release 8.0 or higher, additional upgrade steps may be required.

Enabling IP Office Web Manager

1.The IP Office Web Manager files must be present on the System SD card. This can be done in a number of way:

•By selecting to include those files when prompted to do so while recreating the IP Office SD card using IP Office Manager.

•By selecting Upload System Files when upgrading the system using IP Office Manager.

2.The IP Office system security must allow IP Office Web Manager operation:

•This is done automatically for any new system installed with IP Office Release 8.0 or higher software.

•This is done automatically for any existing pre-IP Office Release 8.0 system during the upgrade if the system is set to use the pre-IP Office Release 8.0 default password.

•For any system upgraded to IP Office Release 8.0 without first being set back to the default password, either:

•Using IP Office Manager:

1.If not already done, select View | Advanced View.

2.Select File | Advanced | Erase Security Settings (Default).

3.From the Select IP Office dialog, select the required system and click OK.

4.Enter the user name Administrator and the password for that account.

5.IP Office Manager will confirm if the action was successful or not.

•Default the system security settings using an RS232 DTE cable.