The modules default to DS phone port operation. The mode of any particular module can be changed though the system configuration.
The processes below require the IP Office system to reboot in order to apply any changes made. The reboot ends all current calls and services.
•DS16B/DS30B Upgrade Behavior:
For DS16B/DS30B modules the process of loading the appropriate firmware for the selected mode or upgrading takes up to 10 minutes during which time the module is not available.
•DS16B2/DS30B2 Upgrade Behavior:
The behavior of DS16/30B2 during firmware upgrade or switching modes differs from other external expansion units:
•During the firmware upgrade, the unit remains operational and can make and receive calls.
•Once the upgrade is completed (approximately 9 minutes) the unit reboots and takes about 45 seconds to return to normal operation.
1.Within the configuration, select Control Unit. The control unit and external expansion modules are listed.
2.The IP500 DS16B and IP500 DS30B modules are listed as DIG ADPx16 RJ45 and DIG ADPx30 RJ45.
3.Select one of the external expansion modules. In the unit details, the Operating Mode drop-down list is used to select what type of phones the module supports. Select the required mode.
•For DS ports, select DS.
•For BST ports, select BST.
•Continue the basic configuration using the following sections of this chapter and then save the configuration when finished.
•Save the configuration as it currently is. This may cause the system to reboot, the save menu will indicate if that is required. After saving the configuration, reload the configuration and continue with configuration.