Adding a Pre-Built Configuration File

IP Office Manager can be used to save a configuration as an off-line file. That file can then be edited and placed on a system's System SD card prior to its installation. That file is then loaded when the new system is started.

•The configuration created must match the physical equipment in the IP Office system onto which it is loaded. Doing otherwise may cause the IP Office system to reset and experience other problems.

To load a pre-built offline configuration onto a System SD card

1.Using IP Office, create an offline configuration that matches the customer requirements and the equipment that will be installed in the IP Office.

2.Rename the configuration file config.cfg.

3.Using a card reader, copy the file into the /system/primary folder on the System SD memory card.