1.Press button-left Admin or button-left Admin 1. See Display Key Programming.  

2.To switch to longhand programming mode, press Expl? button-right.

3.Press Next button-right until the required function required is shown, then press Selct button-right.

4.If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter the data using the normal telephone keypad.

5.The upper part of the display reverts to showing the functions currently assigned to each button-left and button-right.

6.To move between the pages of display keys, press button_half_left and button_half_right.

7.To select the display key against which to program the new function, press button-left or button-right.
Caution
Do not select the slot used for the Admin function. Replacing this function will lock the phone for further programming until reset through the telephone system.

8.If the display slot is not already used, the display shows BUTTON PROGRAMMED!.

•To end programming, press button_exit EXIT.

•To continue programming other functions, press button-left Cont.

9.If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Press button_half_left or button_half_right until Repla, Keep and Delet are shown along the right-hand edge of the display.

•Press Repla button-right to replace that existing function with the one just programmed. BUTTON PROGRAMMED! is displayed.

•To keep the existing function and forget the function just programmed, press Keep button-right.

•To delete the existing function and forget the function just programmed, press Delete button-right.