Please enable JavaScript to view this site.

IP500 V2/V2A IP Office Basic Edition

Connect any digital phones to their appropriate DS ports. These phones may need to upgrade their firmware to match that supported by the IP Office core software. The appropriate firmware is supplied with the IP Office Manager software and copied onto the System SD card for IP500 V2/V2A systems.

The phones will automatically load the firmware from the IP Office system if necessary.

The upgrade process takes approximately 10 minutes during which time the phone will display a warning. The phone should not be disconnected during this process.

Once the phone connected to a port has been upgraded, the IP Office will not check whether the phone on that port needs to be upgraded again except following a system reboot, i.e. multiple phones cannot be upgraded by swapping the connected phones on the same port.

 

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by ™, ® or © are registered trademarks or trademarks respectively are the property of their respective owners.

© 2022 AVAYA
Issue 38.g.-
Tuesday, July 19, 2022