This card is used to add analog phone ports to the control unit. It is available in two variants, providing either 2 or 8 analog extension ports.
|
•Supports •Maximum per Control Unit: 4. •Trunk Card Support: ✓ 1. •IP Office Modes: Supported in all modes. |
Port Type |
Ports |
Features |
||||||||
Analog Phone |
1 to 8 |
•Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20. •REN 2 (1 for external bell device). •Off-Hook current: 25mA •Ring Voltage: 40V. •Intended for connection to two-wire analog phones, the ports do not include a ringing capacitor. For connection to 4-wire analog phones, connection should be via a master socket with ringing capacitors. •If fitted with an analog trunk card, for the Phone 8, during power failure extension port 8 is connected to the analog trunk port 12. Port LEDs•No status LEDs are used for analog phone extensions. •LED1 is also used for base card status:
|
||||||||
Optional Trunk Card Ports |
9 to 12 |
The card can be fitted with one trunk daughter card of any type. The trunk daughter card then uses ports 9 to 12 on the base card for its trunk connections. Port LEDsLED use depends on the type of daughter card installed on the base card: •LED 9 is also used for daughter card status.
|
Name |
Description |
SAP Code |
|---|---|---|
IPO 500 Extn Card Phone 2 |
IP Office 500 Extension Card Phone 2 |
700431778 |
IPO 500 Extn Card Phone 8 |
IP Office 500 Extension Card Phone 8 |
700417231 |