Please enable JavaScript to view this site.

IP500 V2/V2A IP Office Basic Edition

IP Office control units and modules are designed to be installed either in a free-standing stack or into a 19" rack system. Rack installation requires a rack mounting kit for each control unit and expansion module.

Cable Clearance
Clearance must be provided at the front and rear for cable access. On control units, allow a minimum clearance of 90mm (3.5 inches). On external expansion modules allow 75mm (3 inches).

Additional Clearance
Care should be taken to ensure that the positioning of the modules does not interrupt air flow and other factors that may affect environmental requirements.  This is especially important for control units as these  have ventilation slots on both sides and the rear.

Cable Access
Power cords must not be attached to the building surface or run through walls, ceilings, floors and similar openings. Installation measures must be taken to prevent physical damage to the power supply cord, including proper routing of the power supply cord and provision of a socket outlet near the fixed equipment or positioning of the equipment near a socket outlet.

 

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by ™, ® or © are registered trademarks or trademarks respectively are the property of their respective owners.

Use of this site indicates acceptance of its cookies and analytics, and acceptance of the Avaya privacy policy.

© 2022 AVAYA
Issue 38.g.-
Tuesday, July 19, 2022