Date and Time

Network Time Synchronization

Network time synchronization lets you synchronize the telephone system time and date with the network time information that your service provider includes on calls that include caller ID. If network time synchronization is not selected the system time has to be set manually.

If network time synchronization is set to Active and your service provider sends Caller ID from another time zone, the system clock will not match your local time.
Note that this feature uses the first analog trunk on the card installed in slot 1 of the system control unit.

 

1408/1416/9404/9408/9504/9508 Phone

1.At either of the first two extensions on the system, with the phone idle, press Admin.
2.Use the up arrow up or down down arrow arrow buttons to scroll the display to System Administration. When shown, press Select.
3.Use the up arrow up or down down arrow arrow buttons to scroll the display to System Parameters. When shown, press Select.
Alternatively, dial # and the system administration code.
4.Use the up arrow up or down down arrow arrow buttons to scroll the display to Network Time Synch. When shown, press Select.
5.The current setting is displayed.
6.Press either 1 to display Active (the default setting) or 2 to display Not Active. Alternatively use the left arrow left or right right arrow arrow icons to toggle through the settings or Default to return to the default setting.
Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.

 

M7324/M7324N/M7310/M7310N/T7316/T7316E Phone

1.At either of the first two extensions on the system, with the phone idle, press feature small Feature **config (ie. Feature **266344).
If the system has a system password set, it is requested. Enter the password.
2.The phone displays System Admin.
3.Dial #128. The phone displays Network Time Synch.
4.Press either 1 to display Active (the default setting) or 2 to display Not Active.
Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return to the default setting.
To exit phone based administration at any time, press the Release button. To select a different process use the Next Procedure or Previous Procedure buttons or dial another feature code.

 

ETR 18D/ETR 34D Phone

1.At either or the first two extensions on the system, with the phone idle, press Feature 0 0 followed by two presses of the first intercom or call appearance button.
2.System Administration: is shown on the display.
3.Dial #128. The phone displays Network Time Synch.
4.Press either 1 to display Active (the default setting) or 2 to display Not Active.
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then placing it back in the cradle.

 

 

© 2011 AVAYA
- Issue 3.b.-
11:29, 22 March 2011
(networktimesynchronization.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others.

All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners.

Last Modified: 15/01/2011