System Password

The system password is a four-digit password that users can enter from their telephones to override dialing restrictions if the extension has access to an outside line. Through system administration you can set and change the system password.

•

Once a password is programmed, you must enter it to turn Night Service on and off. Additionally, if night service is on, users in the Night Service Group must enter the password to make any outgoing calls except calls to numbers on the Emergency Phone Number List and marked system speed dial numbers.

•	Dialing restrictions for extensions not in the Night Service Group remain the same as during normal daytime operation.

•	For M-Series and T-Series phones, the system password, if set, is also used to control access to many phone based administration menus.

1.	At either of the first two extensions on the system, with the phone idle, press Admin.

2.	Use the up or down arrow buttons to scroll the display to System Administration. When shown, press Select.

3.	Use the up or down arrow buttons to scroll the display to Restrictions/Permissions. When shown, press Select.

•	Alternatively, dial # and the system administration code.

4.	Use the up or down arrow buttons to scroll the display to Set System Password. When shown, press Select.

5.	Enter the new four digit system password. Use Default to return to the default setting of no password.

•	Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.

1.	At either of the first two extensions on the system, with the phone idle, press Feature config (ie. Feature 266344).

•	If the system has a system password set, it is requested. Enter the password.

•	To exit phone based administration at any time, press the Release button. To select a different process use the Next Procedure or Previous Procedure buttons or dial another feature code.

1.	At either or the first two extensions on the system, with the phone idle, press Feature 0 0 followed by two presses of the first intercom or call appearance button.

•	Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then placing it back in the cradle.

© 2011 Avaya LLC
- Issue 3.b.-
11:29, 22 March 2011
(systempassword.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others.

All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya LLC. All other trademarks are the property of their respective owners.