This type of card can be added to an IP500 base card to provide that card with support for PRI trunks. The card is available in single port or dual port variants.

This card can be fitted to any non-combo IP500 base card except the IP500 4-Port Expansion card and Unified Communications Module.

ip500_pri

•Ports/Channels:
1 or 2 PRI trunk ports. Each port supports the following PRI line types. On dual port cards, both ports will be the same line type. The line type selection can be changed using IP Office Manager. The options available depend on the IP Office operation mode and locale.

•E1 PRI (30B+D channels per port).

•E1R2 PRI (30B channels per port).

•T1 robbed bit (24B channels per port) or T1 PRI (23B+D channels per port).

•The required mode can be selected within IP Office Manager by right-clicking on the line icon and selecting Change Universal PRI Card Line Type and then selecting the required line type.

•Physical trunk connection is via ports 9 and 10 of the host IP500 base card.

•Port 11 and 12 can be used as test points for connection of test and monitoring equipment for the adjacent port.

•Licenses:
The IP Office system supports 8 unlicensed B-channels on each IP500 PRI-U port fitted. Additional B-channels, up to the capacity of ports installed and PRI mode selected require IP500 Universal PRI (Additional Channels) licenses added to the configuration. These additional channels consume the licenses based on which additional channels are configured as in-service from port 9 of slot 1 upwards. D-channels are not affected by licensing.  

•Maximum per Control Unit: 4 per control unit.

•Minimum Software Level:

oIP500 PRI-U Cards: IP Office R4.1+.

oIP500 PRI-U V2 Cards: IP Office R11.1.2.4+

port leds 9-12

Daughter Card Ports (9-12)
The LEDs for ports 9 to 12 of the IP500 base card are used as follows:

•Off = No trunk present.

•Green on = Trunk present.

•Green flashing = Trunk in use.

•Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication signal (AIS) from the trunk remote end.

•Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode (set through IP Office System Monitor).

•LED 9 is also used for daughter card status.

•Red On = Error

•Red Slow Flash = Initializing.

•Red Flash every 5 seconds = Card okay.

•Red Fast Flash = System shutdown.

Name

Description

SAP Code

IPO 500 TRNK PRI UNVRSL SNGL

IP Office 500 Trunk Card Primary Rate 1 Universal

700417439

IPO IP500 TRNK PRI UNVRSL SNGL TAA

" Trade Agreements Act compliant variant.

700501514

IPO 500 TRNK PRI UNVRSL DUAL

IP Office 500 Trunk Card Primary Rate 2 Universal

700417462

IPO IP500 TRNK PRI UNVRSL DUAL TAA

" Trade Agreements Act compliant variant.

700501517

IPO IP500 TRNK PRI V2 UNVRSL SNGL

IP Office 500 Trunk Card Primary Rate 1 Universal V2

700515485

IPO IP500 TRNK PRI UNVRSL SNGL V2 TAA

" Trade Agreements Act compliant variant.

700515487

IPO IP500 TRNK PRI V2 UNVRSL DUAL

IP Office 500 Trunk Card Primary Rate 2 Universal V2

700515486

IPO IP500 TRNK PRI UNVRSL DUAL V2 TAA

" Trade Agreements Act compliant variant.

700515488