Please enable JavaScript to view this site.

IP500 V2 IP Office Essential Edition

The following port types are found on the IP Office control unit and external expansion modules:

ANALOG
Used for the connection of external analog trunks.

AUDIO
Used for input of an external music on hold source.

BRI
Used for connection of BRI trunks (Quad BRI trunk card). In IP Office standard modes they can also be used for ISDN terminals devices (So8 mode).

BST (RJ21) and BST (RJ45)
Connections for M-Series and T-Series phones supported by IP Office. Also for Digital Mobility Solution system supporting 4100 Series and 7400 Series phones. See supported Avaya BST digital phones.

DC I/P
Power input from external power supply unit.

DS
Connection of Avaya digital station phones supported by IP Office.

RS232/DTE
Used for control unit maintenance under Avaya guidance. On expansion modules not used.

EXPANSION
Used for interconnection of external expansions modules and control units.

EXT O/P
Used to control external relay systems. The port provides two switchable (on, off and pulse) controls.

ground symbol
Used for connection of functional or protective ground if required.

LAN
10/100Mbps Ethernet LAN ports.

PF
Analog power fails ports.

PHONE (POT)
Analog phone extension ports. On older units these ports are labeled as POT ports.

PRI
PRI trunk ports.

 

 

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by ™, ® or © are registered trademarks or trademarks respectively are the property of their respective owners.

© 2021 AVAYA
Issue 37.f.-
Tuesday, March 30, 2021