If replacing with a component of the same type but higher capacity, when restarted the IP Office will automatically create configuration entries for the new trunks or extensions/users.

To replace a component with one of the same type but higher capacity

1.Shutdown the system.

2.Switch off power to the system.

3.Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must be installed in the same position.

4.Install the replacement using the appropriate process for the type of component (Fitting IP500 cards, Adding External Expansion Modules).

5.Restart the IP Office system.

6.Use IP Office Manager to configure the new trunks or extensions/users.