Please enable JavaScript to view this site.

IP500 V2/V2A IP Office Basic Edition

If replacing with a component of the same type but lower capacity, after restarting the IP Office the configuration will need to be edited to remove redundant entries.

To replace a component with one of the same type but lower capacity

1.Shutdown the system.

2.Switch off power to the system.

3.Remove the card or external expansion module. Note the card slot or expansion port used as the replacement must be installed in the same position.

4.Install the replacement using the appropriate process for the type of component (Fitting IP500 cards, Adding External Expansion Modules).

5.Restart the IP Office system.

6.Use IP Office Manager to delete the trunks or extensions/users that are no longer supported by the component installed.

 

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by ™, ® or © are registered trademarks or trademarks respectively are the property of their respective owners.

Use of this site indicates acceptance of its cookies and analytics, and acceptance of the Avaya privacy policy.

© 2022 AVAYA
Issue 38.g.-
Tuesday, July 19, 2022