Use this feature to reset the system while retaining the currently programmed settings. Reset the system only when advised to do so by technical support personnel.
This process will restart the phone system and disconnect all currently connected calls.
•The system reset begins immediately. It takes approximately 5 minutes.
•This procedure is not listed when using the Next Procedure or Previous Procedure buttons to select a procedure.
1.At either of the first two extensions on the system, press Admin.
•To do the above during a call, you may need to press the PHONE button to display the Admin soft key option. If you access phone administration during a call, only the SPEAKER, MUTE and HEADSET buttons still affect the connected call.
2.Use the up or down arrow buttons to scroll the display to System Administration. When highlighted, press Select.
4.At the Reset - Save All prompt press Proceed.
1.At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
•If the system has a system password set, it is requested. Enter the password.
2.The phone displays System Admin.
4.At the Reset - Save prompt press Enter.
•To exit phone based administration at any time, press the Release button. To select a different process use the Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1.At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first intercom or call appearance button.
2.System Administration: is shown on the display.
4.At the Reset - Save All prompt press Enter.