This type of card is used to add voice compression channels to the control unit. Those channels are used for VoIP calls including IP extensions and or IP trunks. IP500 V2A control units support up to 148 voice compression channels, using IP500 VCM cards and IP500 Combination Cards.

The cards are available in 32 channel and 64 channel variants. All the card variants have 4 RJ45 ports which are used for trunk connections when an IP500 trunk daughter card is fitted. V2 and V3 VCM cards are identical in supported features and functionality except for minimum supported IP Office version (see below).

ip500 base vcm 3d

Supports
Codecs G.711, G.722, G.729ab, and G.723 with 64ms echo cancellation. The maximum number of simultaneous channels useable on an IP500 VCM base card is affected by the codec being used. The following table assumes that all calls using the VCM use the same codec. Note: Whilst IP500 VCM cards support G729b, it is not supported by other IP Office systems such as Linux based systems.

Codec

IP500 VCM 32 V2/V3

IP500 VCM 64 V2/V3

G.711

32

64

G.729ab

30

60

G.723

22

44

G.722

30

60

Maximum per Control Unit: 2.

IP500 Trunk Card Support: ✓ 1.

IP Office Modes: Not supported in IP Office Basic Edition modes.

Minimum software level:

oVCM V2 Cards: Supported for IP Office R8.1 and higher.

oVCM V3 Cards: Supported for IP Office R11.1.3 and higher.

Port Type

Ports

Features

Not present

1 to 8

LEDs

LEDs 1 to 8 are unlabelled. They are used to indicate voice compression channel usage. Each LED represents 12.5% of available voice compression channel capacity.

LED1 is also used for base card status:

Red On = Error/Not supported.

Red Slow Flash = Initializing.

Red Flash every 5 seconds = Card okay.

Red Fast Flash = System shutdown.

Optional Trunk Card Ports

9 to 12

The card can be fitted with one trunk daughter card of any type. The trunk daughter card then uses ports 9 to 12 on the base card for its trunk connections.

LEDs

LED use depends on the type of daughter card installed on the base card:

LED 9 is also used for daughter card status.

Red On = Error

Red Slow Flash = Initializing.

Red Flash every 5 seconds = Card okay.

Red Fast Flash = System shutdown.

Analog Card

Green on = Line connected to the port but idle.

Green flashing = Line in use.

PRI Card

Off = No trunk present.

Green on = Trunk present.

Green flashing = Trunk in use.

Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication signal (AIS) from the trunk remote end.

Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode (set through IP Office System Monitor).

 

BRI Card

Off = No trunk present.

Green on = Trunk present.

Green flashing = Trunk in use.

 

 

Name

Description

SAP Code

IP500 Voice Compression Modules V2

IPO IP500 MC VCM 32 V2

IP500 Media Card Voice Coding Module 32 V2

700504031

IPO IP500 VCM 32 TAA V2

" Trade Agreements Act compliant variant.

700504033

IPO IP500 MC VCM 64 V2

IP500 Media Card Voice Coding Module 64 V2

700504032

IP500 Voice Compression Modules V3

IPO IP500 VCM 32 V3 MEDIA CARD

IP500 Media Card Voice Coding Module 32 V2

700517168

IPO IP500 VCM 32 V3 MEDIA CARD TAA

" Trade Agreements Act compliant variant.

700517170

IPO IP500 VCM 64 V3 MEDIA CARD

IP500 Media Card Voice Coding Module 64 V2

700517169