ip500 insert card 02

The IP500 V2A control unit has 4 slots for the insertion of IP500 base cards. The slots are numbered 1 to 4 from left to right. Normally they can be used in any order, however if the capacity for a particular type of card is exceeded, the card in the rightmost slot will be disabled.

Each base card includes an integral front panel with ports for cable connections. Typically the first 8 ports on the left are for connection of extension devices. The 4 ports on the left are used for connection of trunks if a trunk daughter card is added to the base card.

IP500 Digital Station Base Card

ip500 base ds8 3d

This card provides 8 DS (digital station) ports for the connection of Avaya digital phones (1400, 2400 and 9500 Series phones).

Maximum:

DS8: 3 per control unit. Supported by IP500 V2 control units only.

DS8A: 4 per control unit. Supported by IP500 V2 and IP500 V2A control units.

IP500 Analog Phone Base Card

ip500 base phone8 3d

The card is available in two variants, supporting either 2 or 8 analog phone ports.

Maximum: 4 per control unit.

The analog phone ports do not include a ringing capacitor. Where this is a requirement, connection should be via a Master socket containing ringing capacitors.

If fitted with an IP500 Analog Trunk daughter card, during power failure phone port 8 is connected to analog trunk port 12.

IP500 VCM Base Card

ip500 base vcm 3d

This card is available in variants supporting either 32 or 64 voice compression channels for use with VoIP calls.

Maximum: 2 per control unit.

The VCM V2 and V3 cards are functionally the same. However, VCM V3 cards are only supported for R11.1.3 and higher.

IP500 4-Port Expansion Base Card

4Port

This card adds an additional 4 expansion ports for external expansion modules. The card is supplied with four 2m yellow interconnect cables.

This card does not accept an IP500 trunk daughter card.

Maximum: 1 per control unit (Right-hand slot 4 only).

Supported Expansion Modules: The following external expansion modules are supported:

IP500 Analogue Trunk Module

IP500 BRI So Module

IP500 Digital Station Module

IP500 Digital Station Module A

IP500 Digital Station Module B

IP500 Phone Module

IP500 BRI Combination Card

combo card bri

This card provides 6 digital station ports (1-6), 2 analog extension ports (7-8) and 2 BRI trunk ports (9-10, 4 channels). The card also includes 10 voice compression channels.

Maximum: 2 per control unit.

IP500 Combination cards are pre-fitted with a trunk daughter card which cannot be removed or changed for another type/capacity trunk daughter card.

IP Office Basic Edition - Norstar Mode and IP Office Basic Edition systems are limited to a maximum of 12 BRI channels using BRI Combination and or BRI trunk daughter cards.

IP500 ATM Combination Card/IP500 ATM Combination Card V2

combo card atm

This card provides 6 digital station ports (1-6), 2 analog extension ports (7-8) and 4 analog trunk ports (9-12). The card also includes 10 voice compression channels.

Maximum: 2 combination cards per control unit.

IP500 Combination cards are pre-fitted with a trunk daughter card which cannot be removed or changed for another type/capacity trunk daughter card.

The analog phone ports do not include a ringing capacitor. Where this is a requirement, connection should be via a Master socket containing ringing capacitors.

During power failure phone port 8 is connected to analog trunk port 12.

Unified Communications Module

ucm_v2_3d

This card acts as an embedded Linux server for the Linux-based one-X Portal for IP Office and/or Voicemail Pro applications.

This card does not accept an IP500 trunk daughter card.

Maximum: 1 per control unit.