These cards are used to add a combination of ports to an IP500 V2 control unit.

combo card atm

Supports

10 voice compression channels. Codec support is G.711, G.722, G.729a, and G.723 with 64ms echo cancellation.

6 Digital Station ports for supported Avaya DS digital telephones (except 3800 Series).

2 Analog Extension ports.

4 Analog Trunk ports:
The analog trunk daughter card is equivalent to an IP500 Analog Trunk Card V2.

During power failure, phone port 8 is connected to analog trunk port 12.

Maximum per Control Unit: 2 combination cards of any type per control unit.

Trunk Card Support: ✓ 1.

IP500 Combination cards are pre-fitted with a trunk daughter card which cannot be removed or changed for another type/capacity trunk daughter card.

IP Office Modes: Supported in all modes.

Minimum Software Level: 8.1 Feature Pack 1+.

Port Type

Ports

Features

Digit Station

1 to 6

Provides DS ports for supported Avaya DS digital telephones.

LEDs

Green Flashing = Phone detected.

Green On = Phone active.

LED1 is also used for base card status:

Red On = Error/Not supported.

Red Slow Flash = Initializing.

Red Flash every 5 seconds = Card okay.

Red Fast Flash = System shutdown.

Analog Phone

7 to 8

Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.

REN 2 (1 for external bell device).

Off-Hook current: 25mA

Ring Voltage: 40V.

Intended for connection to two-wire analog phones, the ports do not include a ringing capacitor. For connection to 4-wire analog phones, connection should be via a master socket with ringing capacitors.

During power failure, extension port 8 is connected to the analog trunk port 12.

No status LEDs are used for analog phone extensions.

Analog Trunk

9 to 12

DTMF, ICLID and busy tone detection.

Over-voltage/lightning protection (may still require additional protection equipment).

DTMF and LD (loop disconnect) dialing.

Echo cancellation.

LEDs

Green on = Line connected to the port but idle.

Green flashing = Line in use.

LED 9 is also used for daughter card status.

Red On = Error

Red Slow Flash = Initializing.

Red Flash every 5 seconds = Card okay.

Red Fast Flash = System shutdown.

Name

Description

SAP Code

IPO IP500 COMB CARD ATM4 V2

IPO IP500 COMBINATION CARD ATM4 V2

700504556