IP Office Essential Edition - Basic Edition Phone Admin: Line Settings
Number of Lines
This feature should only be used during initial system configuration before any other button programming has been performed. If used at any other time, it will override that other button programming.
Use this feature to determine the number of outside lines that should be automatically assigned to buttons on all extensions. For example, entering 06 means that all extensions are assigned lines 01 through 06. For DS and ETR phones, the lines are assigned to the buttons after the intercom (key system mode) or call appearance buttons (PBX system mode). For BST phones the buttons used will depend on the phone model.
By default the system will assign either 5 lines or, if installed, the number of analog trunks installed when the system is first started.
You can use this procedure to limit the number of lines that are automatically assigned to all extensions. For example, if there are ten lines connected to the system, you can use this procedure to set the number of lines to eight, so that only the first eight lines are assigned to all system extensions. You can then use Line Assignment to assign lines 9 and 10 to specific extensions.
To change line assignments without affecting other extensions and settings, use Line Assignment.
On systems running in key system mode, Automatic Line Selection for all extensions is updated to match the same set of lines in sequence followed by the intercom lines.
If an extension is assigned as a doorphone extension, its automatic line selection is reset to select intercom buttons first.
Key System Mode Only
IP Office Essential Edition - IP Office Essential Edition - Basic Edition systems can be installed in either key or PBX system mode. This feature is only supported by systems running in key system mode. The setting is ignored by systems running in PBX system mode.
At either of the first two extensions on the system, with the phone idle, press Admin.
Use the up or down arrow buttons to scroll the display to System Administration. When shown, press Select.
Use the up or down arrow buttons to scroll the display to System Parameters. When shown, press Select.
Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing
by Avaya before they become applicable to any particular order or contract. The company reserves the right to
make alterations or amendments at its own discretion. The publication of information in this document does not
imply freedom from patent or any other protective rights of Avaya or others.
All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other
trademarks are the property of their respective owners.