Once you have shutdown the system, you can insert the module.
•! WARNINGS
•Ensure that you take anti-static protection steps while handling circuit boards.
•Never add or remove cards from the control unit while it has power connected.
•Tools Required
•5mm Flat-blade screwdriver.
•Anti-static wrist strap and ground point.
•USB Installation Key
•PC with System Status Application connection to the IP Office system.
•Monitor and HDMI or HDMI to DVI cable.
To insert the module:
1.Using a flat-bladed screwdriver, remove the blank cover from an unused slot on the front of the control unit.
2.Allowing the module to rest against the bottom of the slot, begin sliding it into the control unit. When half inserted, check that the module rails have engaged with the slot edges by trying to gently rotate it. If the module rotates, remove it and begin inserting it again.
3.While inserting the module, also check to ensure that cables on the module do not interfere with the insertion operation.
4.The module should slide in freely until almost fully inserted. At that point, apply pressure at the base of the front of the module to complete insertion.
5.Using a flat-bladed screwdriver, secure the module.
6.Reapply power to the system.
7.Once the system has fully restarted, check the module LEDs. If the lower LED remains red, the module is not supported by the system. The most likely cause is that the system is not correctly licensed. Recheck the licenses and then restart the system.
8.Once the module's lower LED is green, proceed with installing the module software.