Please enable JavaScript to view this site.

IP500 V2/V2A IP Office Essential Edition

This card is used to add analog phone ports to the control unit. It is available in two variants, providing either 2 or 8 analog extension ports.

ip500 base phone8 3d

Supports
Provides either 8 or 2 analog phone ports depending on card variant.

Maximum per Control Unit: 4.

IP500 Trunk Card Support: tick 1.

IP Office Modes: Supported in all modes.

Port Type

Ports

Features

Analog Phone

1 to 8

Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.

REN 2 (1 for external bell device).

Off-Hook current: 25mA

Ring Voltage: 40V.

Intended for connection to two-wire analog phones, the ports do not include a ringing capacitor. For connection to 4-wire analog phones, connection should be via a master socket with ringing capacitors.

If fitted with an analog trunk card, for the Phone 8, during power failure extension port 8 is connected to the analog trunk port 12.

Port LEDs

No status LEDs are used for analog phone extensions.

LED1 is also used for base card status:

Red On = Error/Not supported.

Red Slow Flash = Initializing.

Red Flash every 5 seconds = Card okay.

Red Fast Flash = System shutdown.

Optional Trunk Card Ports

9 to 12

The card can be fitted with one trunk daughter card of any type. The trunk daughter card then uses ports 9 to 12 on the base card for its trunk connections.

Port LEDs

LED use depends on the type of daughter card installed on the base card:

LED 9 is also used for daughter card status.

Red On = Error

Red Slow Flash = Initializing.

Red Flash every 5 seconds = Card okay.

Red Fast Flash = System shutdown.

Analog Card

Green on = V1: Card installed. V2: Line connected to the port but idle.

Green flashing = Line in use.

PRI Card

Off = No trunk present.

Green on = Trunk present.

Green flashing = Trunk in use.

Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication signal (AIS) from the trunk remote end.

Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode (set through IP Office System Monitor).

 

BRI Card

Off = No trunk present.

Green on = Trunk present.

Green flashing = Trunk in use.

 

Name

Description

SAP Code

IPO 500 Extn Card Phone 2

IP Office 500 Extension Card Phone 2

700431778

IPO 500 Extn Card Phone 8

IP Office 500 Extension Card Phone 8

700417231

 

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others. All trademarks identified by ™, ® or © are registered trademarks or trademarks respectively are the property of their respective owners.

© 2022 AVAYA
Issue 38.f.-
Monday, April 4, 2022