IP500 Base Cards

The IP500 V2 control unit has 4 slots for the insertion of IP500 base cards. The slots are numbered 1 to 4 from left to right. Normally they can be used in any order, however if the capacity for a particular type of card is exceeded, the card in the rightmost slot will be disabled.

Each base card includes an integral front panel with ports for cable connections. Typically the first 8 ports on the left are for connection of extension devices. The 4 ports on the left are used for connection of trunks if a trunk daughter card is added to the base card.

This card provides 8 DS (digital station) ports for the connection of Avaya digital phones (1400, 2400 and 9500 Series phones).

•Maximum:

•DS8: 3 per control unit. Not supported by IP500 V2A control units.

•DS8A: 4 per control unit.

The card is available in two variants, supporting either 2 or 8 analog phone ports.

•Maximum: 4 per control unit.

•The analog phone ports do not include a ringing capacitor. Where this is a requirement, connection should be via a Master socket containing ringing capacitors.

•If fitted with an IP500 Analog Trunk daughter card, during power failure phone port 8 is connected to analog trunk port 12.

This card provides 6 digital station ports (1-6), 2 analog extension ports (7-8) and 2 BRI trunk ports (9-10, 4 channels). The card also includes 10 voice compression channels.

•Maximum: 2 per control unit.

•IP500 Combination cards are pre-fitted with a trunk daughter card which cannot be removed or changed for another type/capacity trunk daughter card.

•IP Office Basic Edition - Norstar Mode and IP Office Basic Edition systems are limited to a maximum of 12 BRI channels using BRI Combination and or BRI trunk daughter cards.

This card provides 6 digital station ports (1-6), 2 analog extension ports (7-8) and 4 analog trunk ports (9-12). The card also includes 10 voice compression channels.

•Maximum: 2 combination cards per control unit.

•IP500 Combination cards are pre-fitted with a trunk daughter card which cannot be removed or changed for another type/capacity trunk daughter card.

•The analog phone ports do not include a ringing capacitor. Where this is a requirement, connection should be via a Master socket containing ringing capacitors.

•During power failure phone port 8 is connected to analog trunk port 12.

This card is only supported in a control unit running in IP Office Basic Edition - PARTNER Mode or IP Office Basic Edition. It provides 6 ETR ports for connection of ETR phones. 2 Analog extension ports are also provided for emergency use only with an analog trunk card.

•Maximum: 3 per control unit.

•The card's analog phone ports do not include ringing capacitors. Where this is a requirement, connection should be via a Master socket containing ringing capacitors.

•If fitted with an IP500 Analog Trunk daughter card, during power failure, ports 7 and 8 allow analog phone connection to the analog trunk port 12. During normal operation, ports 7 and 8 are not useable.