The table below summarizes the supported destinations for DID call mapping and SIP call-by-call settings. The options depend on the trunk type and the operating mode of the system.

DID Call Mapping/SIP Call-by-Call Destinations

Key Mode

PBX Mode


Alog

ETSI PRI

BRI

PRI

T1

SIP

Alog

ETSI PRI

BRI

PRI

T1

SIP

Extension
Route incoming calls to a particular extension.

tick

tick

tick

tick

tick

tick

tick

tick

tick

tick

Phantom Extension
IP Office Release 6.1+ supports phantom extensions. One of these can be selected as the destination for calls.

tick

tick

tick

tick

tick

tick

tick

tick

tick

tick

Hunt Group
Incoming calls can be routed to one of the 6 rotary hunt groups.

tick

tick

tick

tick

tick

tick

tick

tick

tick

tick

Voicemail
Route incoming calls to the systems voicemail to collect messages. This requires the caller to know the mailbox number and passcode.

tick

tick

tick

tick

tick

tick

tick

tick

tick

tick

76: Modem
For Release 6.1+, the option 76: Modem can be selected to route the call to the systems built in V32 modem function. This is intended for basic configuration access by system maintainers.

tick

tick

tick

tick

tick

tick

tick

tick

tick

tick

Auto Attendant
For Release 6.1+, any of the configured voicemail auto attendants can be selected as the call destination.

tick

tick

tick

tick

tick

tick

tick

tick

tick

tick

Operator Group
For systems with their System Mode set to PBX System, incoming calls are routed to the Operator Group.

tick*

tick*

tick*

tick*

tick

Calling Group
For systems with their System Mode set to PBX System, incoming calls can be routed to one of the 4 collective calling groups.

tick

tick

tick

tick

tick

* = Default destination for fixed Default DID entry in DID Call Mapping table, ie. matches any call where there is no other specific match.